PDA

View Full Version : bi-amp

paymontana
10-05-2003, 08:20 AM
If i were to buy a 7 ch amp could i use it and the 7ch amp out of my reciever to biamp my speakers?

Thankyou
CJ
Tour2ma
10-05-2003, 11:13 AM
Does your AVR have pre-outs for all 7 channels?
paymontana
10-05-2003, 11:50 AM
Yes it does have all 7 pre's but it is currently not working. This think is brand new. It is factory refurbished but for "minor cosmetic flaws" . I think i got the shaft! Any one know how i should handle this! My temper is in check for now!


Thanks
CJ
Tour2ma
10-05-2003, 12:01 PM
Factory refurbished carries full warranty, so other than a little hassel, you should not be out anything.

Contact where you bought it and see where it leads...

Back to your original question.... yes...
gatemplin
10-05-2003, 12:06 PM
What receiver do you have? I'm guessing HK. Do you have to select the multi-channel outputs before they will work? Will both power and preouts work at the same time? Read that manual.
paymontana
10-05-2003, 12:23 PM
I figured out the multichannel deal but this is something else. It was working in stereo mode when i shut it down last night. When i fired it up there was nothing. Then it surged and shut down. It happend befor when i first hooked it up but i thaught it was a wiring problem, now i don't know.

CJ
gatemplin
10-05-2003, 12:31 PM
Check all the speaker connections carefully, it appears to be short. If not talk to the company.