3 single voice coil subs how to wire?

[Bones]

I'm gettin the momo 10's the original ones with the metal cone.. i'm trying to figure a way to wire them off of 1 or 2 amps.. any suggestions?

[exalted512]

parallel into a 1.333 load
need an amp that does like 1600x1@1 ohms
-Cody

[jamas33]

The Kenwood Excelon KAC-X810 does that. If you are interested let me know. I friends at Kenwood and I can seriously save you some money.

[neomagus00]

how much can you get one of the graphic 13 band eq's for?

[jamas33]

Give me the model number and I will ask them.

[PoweredByDodge]

the x810 does not do 1500 or 1600 watts rms! ... last i recall it was like an 800 watt mono amp.

[jamas33]

my mistake. I wasnt paying attention... Its not rms that thing maxes at 1600 but is 1 ohm stable.

[exalted512]

yeah, you need a 1600 watt RMS amp
not peak:)
-Cody

[neomagus00]

if needed, the subs can be wired to 1.6 ohms instead of 1.33. this may make a 2 ohm stable amp less upset, should that become necessary. for 1.6, two are in parallel, and that setup is in series w/ the third.

[Bones]

Thanks fellaz.... i think i'm just going to stick with 2 10's for now... and then upgrade to four later.... do you think that one of the new mono plkc5001 will run those 2 subs fine.. or should i get 2 amps

[neomagus00]

hey jamas33 - the model is KGC-9044 (http://www.kenwoodusa.com/product/product.jsp?productTypeId=28&sortBy=price&productId=457), MSRP $350.