12 O'clock

[Willow]

I read alot that we should not go past 12 on the receiver. Well If I do that I am bearly at -60 on my receiver and I can only watch TV at that volume and just hear what they are saying. So what is with this 12 positioning all about ?

Thanks

[Mike682]

Willow,

Here's a good explanation from Outlaw's FAQ section:

Volume Control on the Model 1050
The Outlaws
"Why do I have to turn the 1050 volume up so high?"

The Model 1050 uses a linear volume control. You will find 54-60 on the dial to be average listening. Most people are more accustomed to logarithmic volume controls. This type typically outputs 90% if its power capabilities by 11:00 on the dial! This is not the case with linear controls. They offer greater accuracy in setting the desired level, and use virtually all of its volume range.

[Vr3MxStyler2k3]

*sigh*...

Subject is getting old.

ZERO on a modern, linear scale receiver - is 12 OCLOCK.

Zero, 12 Oclock = Reference Level

:)

Just turn it up to zero and report back to us. You will experience reference level and 12 oclock at the same time. Its a great experience on dynamic recordings. Really.

[Willow]

it may be to some one who has 8K + posts.

But thanks for the answer I was just reading the polks Q&A's and saw this I remembered reading the answer somewhere but couldn't find it so I thought I'd ask.

[F1nut]

Originally posted by Vr3MxStyler2k3

Zero, 12 Oclock = Reference Level



That really depends on the gear and is not a guideline one should follow.

[Vr3MxStyler2k3]

In general, zero on a linear volume control is reference level.

Reference level is where the amplifier is giving ALL it has to the passage.

Yes, sometimes a recording may be toned down, while others are amped up.

There are way to many variables to consider. But in a perfect world. Zero is your friend.

Which you have obviously found Mr. 130 db! ;) :p