SRS 1.2TL Impedance [Archive]

Reagan

11-05-2005, 04:57 PM

I recently acquired a set of 1.2TL's. They are described on the Polk website as "Nominal 8 Ohm" speakers. My amp has a 4 ohm setting and an 8 ohm setting. Which should I use? I am not bi-amping.

schwarcw

11-05-2005, 05:15 PM

Welcome to the Forum Reagan! I don't have the info you need. But don't worry, someone who knows will post a reply

BlueMDPicker

11-05-2005, 06:15 PM

The original spec table reads "Compatible with 8 ohm outputs". Use the 8 ohm tap would be my recommendation.

BTW - Welcome!

ND13

11-05-2005, 06:58 PM

http://www.polkaudio.com/homeaudio/specs/srs12tl/

I'd use the 8ohm tap^^^^

Welcome to the SDA club!!!

BobMcG

11-05-2005, 07:28 PM

Welcome to the forums and one more time.... can't go wrong with the 8 ohm setting.

F1nut

11-05-2005, 08:10 PM

A more acurate rating puts them at 6 ohms, so use the 8 ohm tap.

jfb4548

11-05-2005, 08:30 PM

A more acurate rating puts them at 6 ohms, so use the 8 ohm tap.

Are the SRS 8 ohm also? I was thinking less, but it's been years since I hooked um up?? :rolleyes:

BobMcG

11-05-2005, 09:08 PM

Are the SRS 8 ohm also? I was thinking less, but it's been years since I hooked um up?? :rolleyes:

SRSs are pegged by Polk at 4 ohm.

Other SRS trivia includes max output at 125dB and efficiency of 93dB. :)