LSiC Setting

[ezc]

Should the center chanel be set to large or small?
I have a LSiC & LSi15 mains The manis are set to large Should the center be set to large too? The center LSic one driver plays mids & vocals, the seccond driver plays only lows ( no vocals) & the tweter plays the highs. What would be the reccomended setting. I tried both & both sounds good. Seems on large the dialoug may be slightly harder to hear. Any advice?

[hoosier21]

PROCESSOR MODE CONFIGURATION
FOR THE LSi SERIES CENTER CHANNEL LOUDSPEAKER
The “bass management” or “speaker configuration” menus of most surround receivers offer the
choice of “normal” or “wide” modes for center channel operation. In discrete channel digital
processors these modes are referred to as “small” and “large.” Normal (small) mode filters bass
frequencies from the center channel speaker and sends them instead to the front left & right main
speakers or to the subwoofer output (LFE) jack. Wide (large) mode sends an unfiltered, full range
signal to the center channel speaker. Use the Small (normal) mode for optimum center (and
surround) channel performance and reliability.

[jrausch]

Large is used for center channels with built in woofers or powered subs.