Blown mid-range? [Archive]

rt1000jimbo

03-04-2006, 03:20 PM

How do I remove the mid range from my RT1000i to check if it is blown? :confused:

Vr3MxStyler2k3

03-05-2006, 02:37 PM

That thing has the baffle right?

Take out the allen screws - the woofer is just setting in there... (pressure fitted with the baffle)...

Eric Wong

03-06-2006, 10:52 AM

Yup, they are 9/64". Lie the speaker on its back to take out the mid range driver.

rt1000jimbo

03-06-2006, 06:50 PM

Got it! The thing was press fit so tightly I wasn't sure if it was fastened from the inside. All indications are that the speaker is blown. Is there anyway to repair the thing? or would it be best replace it?.Thanks guys.

Jimbo

simmtron

03-10-2006, 01:03 AM

Your out of luck, they don't make the speakers for this speaker anymore. I needed a replacement for my rt2000i they said to use speaker from rti8 series, which means replacing both speakers (better imaging). I found someone selling one speaker on ebay with woofer I needed. A lot cheaper too.

rt1000jimbo

03-11-2006, 03:23 PM

MW7200 speakers were still available. Replaced blown with same available from polk.