I would like to put a built in fan in my HK7200

[SOUNDMASTER5158]

I would like to put a built in fan kinda like a computer fan on the top of my unit right directly in the middle where I have room between the amplifiers.

What I would like to know is how can it be done and is their a way to plug or soder the wires too it.

Any info is greatly appreciated.

tyia
Eric

[danger boy]

why?

unless it's overheating and shutting down into protect mode.. you dont need a fan.

[SOUNDMASTER5158]

The reason why is becasue I want to keep it cooler and to make sure I do not start the overheating or protect mode. once the unit starts doing it no matter what you do it will keep doing it and besides have you seen my layout on the electronics I own it all gets very warm inside even though they all have about 12 inches of breathing room top to bottom and side to side. not only that plus my warrenty ran out 2 months ago and I do not want to have to spend $3000 again on a decent reciever.

[VR3]

Get a different receiver.

$3,000?

Scratch get the receiver idea, get a preamp + amps.

Or get a real receiver, from B&K or Rotel, etc.

[dorokusai]

Any ad-hoc wiring utilizing the existing equipment is not a good idea.

If you seriously want some pre-built cooling solutions, Active Thermal (http://www.activethermal.com/default.htm), is one source for the gear. If you want to save some money, there are a number of DIY ideas for this application as well...just search the web.

[Early B.]

I agree with danger boy -- forget about it.

Generally, HK receivers run a bit hotter by design. Just make sure you give it adequate ventillation and you'll be OK.

[SOUNDMASTER5158]

Any ad-hoc wiring utilizing the existing equipment is not a good idea.

If you seriously want some pre-built cooling solutions, Active Thermal (http://www.activethermal.com/default.htm), is one source for the gear. If you want to save some money, there are a number of DIY ideas for this application as well...just search the web.
Thank you for the idea.
Eric