Looking for SRS2 crossover info

[jcaut]

I'm thinking about some crossover upgrades for my SRS2's. They have the blade/blade cable and no bi-wire capability. Does anyone have a schematic or at least a list of the values of caps and resistors I'd need? I searched and found a thread detailing some crossover upgrades for SRS2's, but the were the later models with the four binding posts and I figure mine are different.

Thanks,
Jason

[F1nut]

This is for one crossover.

(3) 2.7 ohm
(1) 3.5 ohm
(1) 750pF
(1) 4.4uF
(1) 12uF
(2) 34uF
(1) 55uF
(1) 130uF


Edit to eliminate any confusion.

[schwarcw]

Here ya go! Courtesy of Darqueknight's SDA Compendium Vol. 2. I recommend that you PM him and buy one.

[jcaut]

Thanks Jesse, Carl and Raife. I DO need to get a copy of that SDA compendium. I'll put that on my list.

Jason

[DarqueKnight]

The resistor just after the polyswitch is 3.5 ohms.
There capacitor above the 130 uf capacitor is 55 uF.

[ben62670]

Buy The Book you will not be disappointed. Anyone who enjoys any SDA/SRS should have this book. Anyone thinking of purchasing any of the same should also purchase this book before investing in said speakers.

Enjoy Ben