Please help me wire my 2 channel amp...

[Bluechulappa]

Hi, I'm a total newb but I really need help from people with the know how. No one in my area seems to be able to help me with my DIY project.

I have two Polk Momo 2104 10" subwoofers in a custom box I made from scratch.
These: http://www.polkaudio.com/caraudio/products/mm2104/

And I have this pioneer amp:
http://www.pioneerelectronics.com/pna/v3/pg/product/details/0,,2076_310069933_291559003,00.html

So what is the proper way to wire these subs to this 2 channel amp? I have tried almost every way except parallel and series.

My problem is when I turn up the volume on the headunit... Sometimes the amp will just shut off for a few seconds... It shouldn't do this, I know my amp has enough power for this job! PLEASE HELP
THANKS

[F1nut]

Post your question in the "On The Move" section below. You'll get more attention there.

[jakelm]

Ohms are too low. Probably running a 2 ohm load with an 4 or 8 ohm stable amp. Try Wiring the subs in series.