Matching AVR RTi 10

[sudhirsh]

I have recently purchased RTi 10/FXi3/PSW404/CSI3 and going to use it with Onkyo 804. Is anybody using this combination? as per technical details of both there should not be any problem.

[sudhirsh]

matching help

[bringit167]

I'm using a very similar setup, I have the Rti10's, CSi5, FXi5, and a velodyne dps12 subwoofer. I'm using the Onkyo 803, and everything sounds good in my room! =) However, I still have been debating on buying a seperate amp to see if I could tell a huge difference with the extra power to the rti10's. You should like your setup.

[anonymouse]

A separate amp, at least for the fronts will really open them up.

[crd2002]

I have same setup but with RTI12 's added a earthquake cinenova7 and now the more I raise the volume the better they sound big difference cristal clear sound

[Sherardp]

I have same setup but with RTI12 's added a earthquake cinenova7 and now the more I raise the volume the better they sound big difference cristal clear sound

Are you biamping your 12s or just running them off your power amp?

[crd2002]

I run all speakers from the amp only nothing from the onkyo

[af chief]

I'm close to that setup...804, Rti8s, CSi3, old surrounds for now. From what I've read, Onkyo amp fans will tell you they're a good match for Polk speakers.

[sabotg]

I'm using a very similar setup, I have the Rti10's, CSi5, FXi5, and a velodyne dps12 subwoofer. I'm using the Onkyo 803, and everything sounds good in my room! =) However, I still have been debating on buying a seperate amp to see if I could tell a huge difference with the extra power to the rti10's. You should like your setup.

I'm running almost the same setup but with the Velodyne DLSR-15 Sub and the Pioneer Elite VSX72-TXV receiver. It replaced an older Onkyo and really opened up the Polk's.