unc2701
08-18-2007, 06:48 PM
$200 plus shipping.
Great receiver, just a little older. Might have a few minor scratches, but nothing worth mentioning. Has all the usual 6.1 codecs, PLUS pre-outs. Lived most it's life doing pre-amp only duty for me, so the amp section has pretty low hours. Note that it's got component switching and 2nd room capabilities. Hell, I'll even throw in a spare Niles IR blinker if you need it. Half decent phono stage, too.
This will push 4ohm speakers. Not great, but you can get decent levels out of it before it'll kick over into protection. With a 2-channel power amp I managed to run a 5.1 LSi system off of it just fine (front and surrounds on this receiver).
Will do 100 watts, 20hz-20khz at 0.04% THD into 8 ohms. I have the original box, manual, remote (universal w/ macros).
Setup via On Screen Display.
Digital inputs can be assigned to any input (say- phono if you really wanted to go there) and component video can also be assigned to any input.
PM or post here with any questions.
Great receiver, just a little older. Might have a few minor scratches, but nothing worth mentioning. Has all the usual 6.1 codecs, PLUS pre-outs. Lived most it's life doing pre-amp only duty for me, so the amp section has pretty low hours. Note that it's got component switching and 2nd room capabilities. Hell, I'll even throw in a spare Niles IR blinker if you need it. Half decent phono stage, too.
This will push 4ohm speakers. Not great, but you can get decent levels out of it before it'll kick over into protection. With a 2-channel power amp I managed to run a 5.1 LSi system off of it just fine (front and surrounds on this receiver).
Will do 100 watts, 20hz-20khz at 0.04% THD into 8 ohms. I have the original box, manual, remote (universal w/ macros).
Setup via On Screen Display.
Digital inputs can be assigned to any input (say- phono if you really wanted to go there) and component video can also be assigned to any input.
PM or post here with any questions.