wiring 2 subs

[Knucklehead]

Question: If I have 2 PSW10 subs with only 1 sub out on my AVR, what is the best way to hook this up? Im assuming a "Y" splitter? Thanks in advance!

[BlueFox]

Question: If I have 2 PSW10 subs with only 1 sub out on my AVR, what is the best way to hook this up? Im assuming a "Y" splitter? Thanks in advance!

Hopefully, your sub supports pre-amp in, so take the front pre-amps of the AVR and send it to the sub. Then take the pre-amp out off the sub and run it to the pre-amp in on the second sub.

If you are running your front pre-amps to an amp then the amp should have output connectors for just this reason. This is how my sub is wired, off the pre-amp out on the amp.

[comfortablycurt]

Get a 1 male to 2 female Y-adapter, and a coax cable from each side of the Y to the two subs, and you'll be in business.

[timmythugs]

blue you are gonna confuse this poor guy. Y adapt it and be done!

[Mike21]

http://www.parts-express.com/pe/showdetl.cfm?Partnumber=184-224&FTR=184-224&CFID=6165939&CFTOKEN=15370345

[Knucklehead]

thanks guys, i appreciate it.

[Knucklehead]

Now that i have my 2nd psw10, where should the second one be placed, the first is in the front next to the R50.

[cnh]

There will probably be a number of opinions on this one. But I would 'start' with front placement, one on either side of the L/R fronts. And see what the base sounds like from there.

cnh

[Mike21]

Hi Knuck.

Don't hesitate to experiment with placement.

I recommend you try stacking one atop the other. Works like a charm for my 2Sony 10" by 100w.

[Knucklehead]

yeah, ive had several suggestions for stacking, thanks guys.