Dynamat Extreme DIY cutting tool

[Toolfan66]

Well I made a cutting to to cut the DE.

I took a piece of pipe and sharpened the end to punch Quarter sized circles for my drivers. I punched enough to do my 1.2tl's and my 1C's.

It worked really well 1 good wack with a rubber mallet.

[F1nut]

Ok I'll bite, what are all the little circles for?

[Toolfan66]

Ok I'll bite, what are all the little circles for?

I am going to put them on my drivers one on each post. I really dont think you need more then that.

I will post pics.

They are a little bigger then a quarter, and a lot faster to cut this way.

[F1nut]

I suggest covering the spokes with more than that. A razor knife and straight edge or large scissors work very well.

[Face]

Carpet scissors work great.

[zingo]

Carpet scissors work great.

What about carpet bombing?

[leroyjr1]

Put your wife's muffler tip back on before she finds out.

[Toolfan66]

This worked very well IMO, I really don't see where you need to cover the whole spoke
And the circles I cut cover most of the spoke.

I put eight per driver, and it took the ring out of them.

I did cut strips for the passive.

I am very happy with the results.

[mmadden28]

Well I made a cutting to to cut the DE.

I took a piece of pipe and sharpened the end to punch Quarter sized circles for my drivers. I punched enough to do my 1.2tl's and my 1C's.

It worked really well 1 good wack with a rubber mallet.

Good idea. Now, Pics of the finished drivers!!

Where do you notice the improvement? In any particular piece of music or frequency?

[Zeros]

Yeah, I'd love to see pics of the finished speakers...

[Zeros]

I would guess it is better on the low frequencies, but that's like I said, a guess.

[Toolfan66]

I will post some pics and my thoughts later tonight.