New setup of Polk Speakers
Hi, This is my first post after making my first polkaudio purchase.
I have just purchased the below Polk speakers as an upgrade to my old system. Pioneer Amp is only 18 months old. So at the moment I have stuck with it.
1. Amp settings: I have set the front and centre to large (rears to small) and the cross-over frequency in the amp to 50Hz (options where 50, 80, 100, 120Hz) and used the Subwoofer PLUS option which says "PLUS setting if you want subwoofer to output bass sound continuously or you want deeper bass(bass freq. the would normal come out the front and center are also routed to the subwoofer.
I feel/hear this config is giving me the best bass response but i'm unsure where I should set the cross-over dial on the back of PSW120 given this config in the Amp or if the 50Hz is correct.
2. Presently I have just connected the speaker wire to the TSi500s and using the stock link? between the 2 sets of speaker connections. Is there any recommendation for change in this setup. By-Amping and By-Wiring I still need to research more before bying another Amp. Also seen that changing the stock link with high grade speaker cable. Is this a must?
3. Would also like feedback on my Amp and if it is wasting the money I just spent on these speakers.