setting speaker levels with sound level meter
ok...I just hooked up my rt800i's and SVS 25-31...
I am starting to calibrate the speakers...
I have a Kenwood vr-6070 (looking at getting a HK 635...3-4 years is apparently too long for me to go without upgrading :D )..
I am using it's internal speaker tones with the sound level meter...should I be using a setup disk's tones, instead..? or doesn't it really matter?
also..in the SVS manual, it says to have the subwoofer gain level at 1/3 to start...and the level from the receiver at 1/4 max (mine goes from -10 to +10)
so i set to -5..
since the reading for the sub was too low, I raised the volume on the subwoofer gain to just over half for correct settings...the receiver level was left at -5...did I do this correctly?