Search:

Glad to see them in proper hands, I was hoping someone from the club would snag them!

That is unfortunate, I was hoping someone on here would snag them. Ah well, better luck next time!

Looks like a good price on a set of SDA SRS in LA:
http://losangeles.craigslist.org/wst/msg/3524668500.html

Not sure about condition, but $350 could end up being a hell of a deal. No affiliation.

Hmm, I think I got it. Found a few pages on capacitor cascades and bypass caps, and the smaller value caps are used to bolster the higher frequencies, supporting a smoother wide frequency spectrum. I...

I used double sided sticky foam tape between the caps, which gives them some cushion, and helped hold them in place for the hot glue.

For the cap values, I was under the impression that parallel...

Yes, you should try to get close to the specified capacitance.

Fortunately, caps in parallel are added, so 3x 25 uF in parallel will give you a toal of 75 uF, as would a 50uF and a 25uF (The...

What happens when loudness is off? That button can cause a lot of problems ;)

The tweeters take a little time to break in, and some people say it gets worse before it gets better, so give them a while before you decide. Also, the 15's are known to have the crossover set a...

A mod has to do that, and it will probably happen in a few hours anyway. If you are thinking about rebuilding the speakers, you can get new tweeters from Polk and a discount if you mention you are a...

You have to have 100 posts to sell anything, and there is no quick way to get that without ruining your cred.

When you get to that point, there is a specific For Sale classifieds section of the...

From a dimensional standpoint, the drivers on the monitor 10's have just as much space between them as a pair of SDA 1C's, which are generally well regarded.

My gut feeling is that much of what...

Got mine today, thanks!

I'll take, er... 40? Nothing wrong with spares.

I stand corrected, 585 was stereo. Need more coffee.

I agree that the later 5XXX series were not common ground, when they switched to MOFSET, but the 5X5 line are all common ground, with the exception of the mono blocks (565, 585).

The Adcom 555 series I & II are common ground. I have a 555 Mark II that run a pair of SDA's and it is a very enjoyable combo. The only non-common grounds that I am aware of from Adcom in that time...

In for 10

I completely agree with your assessment, and I should have mentioned that this is entirely a screw around project for me. I enjoy blowing off steam with a soldering iron or a dremel in my hand. I...

So, I have a couple of blown SL2000 tweets sitting around, and I have been considering taking the face plates and modifying them to accept a vifa 1" ring radiator tweeter after listening to a set of...

Low pass knob sets the crossover point of the sub, so if it is set at 100, then the sub will kick in at 100hz and lower. Use this knob to blend the sub with your system. If your mains dig pretty...

I had my 1989 1C's open over the weekend to toss in some new x-overs (Thanks again Gimpod!), here is a pic from the passive in unmolested form:http://i.imgur.com/pdfTu.jpg

Sounds like someone may...

No worries, your Paypal should now be brimming with cash ;)

I PMed you about the P/B, so if Esav backs out, please let me know.

I had a great time in Ireland, a few weeks was not nearly enough :)

If you like trad, take the musicians tour in temple bar, it is a good start. Outside of Dublin, ask around, most pubs have...

I have 2000's in most of my polk speakers (1C, lots of monitors, etc.) but I went with 194's for the office because I spend most of my listening time there and it only took 2 to upgrade the monitor...