Search:

I guess I will have to read over this post or your other to get all the info but I may PM you if I need a bit of help. I hope you are enjoying them.

That is great, I guess that will be the route I take when I restore my 2A's. I think that I am also going to put some real wood veneer on them while I'm at it. Thanks again for the update.

That is great. Please post your comments once you get it completed. I picked up a pair of SDA 2A's a few weeks ago and I am also curious about the upgrade. Good luck!

I hooked them up yesterday and ran them at a decent level for an audition, about 10 watts RMS without a problem. I need to find a bigger amp/receiver in the future.

I thought I would provide a quick update. The SDA's are fully functional and sound great, even though they were not setup properly in the middle of the garage. I posted a couple of pics in which you...

I have a 9090, not a DB model. Here is an AK link that states that a 4 ohm load should be fine if your receiver (9090, 9090DB) is running properly:...

That first link is great for identification, and the other explains the technology well. Thanks!

I just want to say thanks to all for your feedback! A few pokes at another member and there replies only add a bit of character to the thread, I am not offended or nor does it reflect upon other...

My leads when shorted read about 0.3 ohms, so that would put my readings at about 4.4 ohms. I think that this would be considered a good reading.

I have a 9090, not a DB model. Here is an AK link that states that a 4 ohm load should be fine if your receiver is running properly....

I think that you meant that you would be concerned if the measurement was lower than expected (i.e. something shorted). I agree with the reading being a little higher and will probably hook them up...

I would first like to say hello to all of the Club Polk members since this is my first post here. As the title of the post indicates, I just acquired a pair of SDA 2A's. I have been reading quite a...