Search:

How do I add my system contents to accompany all my Thread Posts?

Thanks for the info. Also I misstated the SRS 2's, they are SRS 2.3's.

My SDA II's don't look like the others I've seen on this Forum. What do I have? They have 3 Drivers, 2 soft dome Tweeters and 1 Passive Radiator. Also, should I spike my SDA SRS 2's? They sit on 1/2...

Always, as heavy as you can be and also practical is good. If you have Dolby Digital for your movies, then your back speakers should be set at large because the complete frequency range is delivered...

I am powering my 2.3's with a Yamaha RX-V3000 line outs to a QSC RMX-850. I have a Carver TFM-22 also. Thoughts? I've heard pro's and con's about Pro Amps. I like the extra power and headroom but I...

I recently had a crossover meltdown in one of my 2.3's. Had trouble on my end finding any repair help or replacement parts. Gimpod really came through and helped me fix these vintage pieces. His work...

don't have a good local electronics store. Any advice?

I was so excited. Darn! I have been using a Cerwin Vega as a replacement. Not the same.....Help, I need a SDA 2.3 crossover.

Still waiting to hear from GIMPOD.

Thanks for the advice. I'm new at this.

Brad L. Gilles
668 Ft. Couch Rd.
Pittsburgh, PA. 15241

Boards loaded? Would love any help.

Found out the problem...was running 1 side with a Nady 1100 bridged which was not common grounded,...

Gimpod, Still interrested in that inductor. Find one in your stash?

I would be very interrested in the inductor. All other speakers chk'd ok. Swapped good xover to check. Running my whole system with Pro Amps. Left over from the old band days. I have a Yamaha...

Xovers still available? Will they work for SAD 2.3's?

I have a vintage Carver amp. TFM-22. Would that be better?

Why is the QSC a problem? Do the new boards have the components installed?

Thanks for thew replies. It is the bottom inductor and it is cooked and unusable. I'm using a QSC RMX 850 for power. I pulled all other components dealing with the high end off the board and they all...

One of the coils on the crossover board got hot and melted it's plastic. I have checked all the resistors and caps on the board with a meter and the Schematic and they are ok. I need to replace this...