I ran the 8's for a couple of years, and truly enjoyed them with a good sub or two. Without a sub they still produce surprisingly good bass which I suppose is a result of Polk's good cabinet design. ...
Buy Direct M-F 9am - 10:30pm EST 1-866-764-1801
Vist our Online StoreType: Posts; User: GTB
I ran the 8's for a couple of years, and truly enjoyed them with a good sub or two. Without a sub they still produce surprisingly good bass which I suppose is a result of Polk's good cabinet design. ...
Large means that the full frequency output is sent to the speaker. Small splits the output at the specified frequency (sloped output, actually) and sends the lower freq signals to the bass producing...
I can do the same with my 790. Batpig is the way to go if you can't find it by searching the manual or in the menus.
I think I might go that route also. Great idea!
Phew, me too!
Go with the 9s...the Denon should be just fine. Get it all set up and enjoy, then you can start tweaking if needed.
Did you buy that Denon new? The "08" on the end indicates it is from 2008. If...
Don't think 10s are quite what you're looking for, but they are incredible speakers. Check out the vintage section of this forum.
No PSW10.
The 40's are nice, I've used a pair for a couple of years as rears on my 5.1 system.
I'm a big Denon fan...haven't gone wrong yet.
I finished a pair of DIY subs about a month ago, and they are awesome! I'd be happy to send you a pic and more info it you're interested. The depth of their performance has to be heard to be believed!
Yes, it is!
Didn't know that either!
I'd say yes!!
Nutcase!
no!!!!!!!!!!
Yoda says LFE best!
8 ohm good, too!
Greg
Personally, I'd sell the PSW10. I'm going to sell mine.....
Greg
Another effect SOME subs are sensitive to is called "oil canning".
If you take a sub speaker made to work in a ported enclosure and put it in a sealed enclosure, run it hard, the cone could...
I'm not clear on your connection, but the LFE input on the sub should be the only connection from your receiver. The LFE input has no filters and will play everything sent to it, whereas the other...
Can you set the center crossover freq separately?
Going higher with just the center is the opposite of what you want to do.
Go lower, say 60hz on just the center. You are trying to avoid...
I went from one PSW10 to one MicroPro 2000, to two MicroPro 2000's. I can't comment on running two different subs, but I can say that the PSW10 is not likely going to change things much.
For music...
I have a MPro 2000, and struggled with it until yesterday.
My issue wasn't lack of output, it was I had to really drive it hard to get decent volume which would cause it to be over driven during...
CSi5 is the best match for the RTi8. Its a beast, be sure it will fit in your application.
So very impressive! I'm start'n to get the bug my self.
RTi8's are good speakers, under rated in my mind.
Looks good, I agree its an improvement.