Search:

I am not able in access the classified for sale section, so I thought I would ask my question here. I am just doing the final setup my home theatre set-up and I have some Kimber Kable that I have...

I just mounted my 702's they look great up on the wall but are they heavy. One screw we hit a stud. The other one we cutba hole in the wall, stuck a piece of 2'x4 in behind the drywall and screwed...

The Parasound A31 sounds amazing, I hope my wife likes her Valentine gift. The place I picked up the Parasound at was also a Kimber Kable dealer and the owner gave me a fantastic deal on them. So...

My eyes are burning from all the reading I did last night on cables. I have read comments ranging from high end cables are snake oil to if I buy the right cable I will be able to hear Eddie Van...

Thanks for the help guys. I have decided not to biamp or biwire but I am going to get a power amp. to drive the
Left, right and centre.

I have now turn my attention to the 3 cables I need to...

How about a Parasound A31 for the Left, Right and Centre? And then let the ONKYO power the surrounds in a 5.1 o a future 7.1 setup. Would the ONYKO be enough to power 4 702 F/Xs?

Thanks again...

EMOTIVA XPA-3
Three-Channel Power
Amplifier
Power output (all channels driven):
300 watts RMS @ 4 ohm (0.1% THD)
200 watts RMS @ 8 ohm (0.1% THD)

Will this get the job done? I saw on one of...

Here are the specs.


Amplifier Section


Power Output -
All Channels 145 W (8 ohms, 20 Hz-20 kHz,
0.05%, 2 channels driven, FTC)
Front L/R 145 W (8 ohms, 20 Hz-20...

Hello to all, I am new to the forms and I am setting up a new POLK system and I am trying to figure if I should bi wire and/or bi amp my setup. Any help would be greatly appreciated.

I have an...