Free Shipping on All Orders 1-866-764-1801

Vist our Online Store

Search:

Type: Posts; User: DracoAmericanus

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    172

    Ok I will remove the the stuff, I think i can get...

    Ok I will remove the the stuff, I think i can get my hands on some foam gaskets that where from a group buy a few years ago, My friend who I bought them from, I know ordered them but never installed...
  2. Replies
    8
    Views
    238

    lol that's cheaper then i paid for mine and yes...

    lol that's cheaper then i paid for mine and yes they are huge, I felt that mine should have come with a few monkeys from the movie 2001 to worship them, one of my friends managed to get a pair into a...
  3. The tip is almost always positive, and the ring...

    The tip is almost always positive, and the ring (lower part of the 3.5mm jack) being ground, if your not sure use a meter and check it, do not allow the wires to touch each other, to be truthful it's...
  4. Replies
    6
    Views
    172

    I will check for air leaks, it was sealed with a...

    I will check for air leaks, it was sealed with a clay like caulk but maybe i missed something.
    i could add just a bit of flexible glue in one of the spirals in the spider but i am guessing that...
  5. Replies
    6
    Views
    172

    compliance problem? mw6511

    I was having a problem with one driver mechanically bottoming out in my sda srs 2.3 system, I swapped it out for another MW 6511 that had a broken magnet assembly that i was able to recenter and glue...
  6. 30 bucks? not bad, I do admit to having some Bose...

    30 bucks? not bad, I do admit to having some Bose speakers, I am the original owner of the 201 series II I bought as demos and i still have one, it's mate was destroyed in a house fire, I ended up...
  7. All i can say is LOL

    All i can say is LOL
  8. Need Help If it's not under warranty and know how to solder...

    If it's not under warranty and know how to solder i have seen solder failures on the wires that go from the terminal block to the cone on many different brands of speakers, re-soldering some times...
  9. you guys would be horrified on the turn table i...

    you guys would be horrified on the turn table i some times use, QLY55F from JVC yeah i know it's direct drive but what is worse is it was mint and roasted in a house fire back in 2006, the sides are...
  10. can you add a little bit more detail in your...

    can you add a little bit more detail in your question? i have always thought of a pick-up as a device used on instruments and a cartridge being only on a turntable but i have not done pro audio in...
  11. Replies
    10
    Views
    342

    I second that, caps can be sourced from many...

    I second that, caps can be sourced from many places, i would never tell my customers that a cap is not available, there are almost always substitute parts available. I even keep kit boxes of smd caps...
  12. Replies
    16
    Views
    302

    you need something that can remaster the dvd if...

    you need something that can remaster the dvd if you want to change the volume, AnyDVD is a nice program but i know my version can't do that and i can't think of anything that's free either
  13. Replies
    21
    Views
    607

    the size and weight would not prevent me for...

    the size and weight would not prevent me for getting one, it's big and heavy for a reason aside from caps and possibly a cheap relay i doubt you would have any problems with it, the build quality is...
  14. Replies
    10
    Views
    342

    I have seen hdmi cables cause flaky problems,...

    I have seen hdmi cables cause flaky problems, also the pins can become bent, dirty or may have cracked solder at the other side on the board and i second the suggestion to have the fish caps checked,...
  15. Replies
    12
    Views
    312

    yeah the wattage on the back of the amp should be...

    yeah the wattage on the back of the amp should be worst case draw from the outlet and as others have stated that happens under very heavy load, generally the avr will have a short life if it's pushed...
  16. Replies
    3
    Views
    96

    Need Help just make sure the led says it is rated for...

    just make sure the led says it is rated for 12volts and has some form of current limit resistor, most don't unless stated.
    did you have one fail or just looking to upgrade?
  17. Replies
    12
    Views
    249

    .3amp is 300ma and while leds may be better for...

    .3amp is 300ma and while leds may be better for some applications i don't belive this is one of them due to the warm color temp of the lamp and the narrow spread of the leds compared to that of a...
  18. Replies
    25,632
    Views
    1,359,293

    I hate to ask but does tinnitus count at what i...

    I hate to ask but does tinnitus count at what i am currently listing to?
  19. Replies
    48
    Views
    1,273

    yeah i see that now, i guess that's because i...

    yeah i see that now, i guess that's because i don't find deals like that
  20. Replies
    48
    Views
    1,273

    i know one thing, after owning this model i got...

    i know one thing, after owning this model i got good at using a fixture i built to re glue the magnets back in center lol, to my horror even the tweeters have the same glue fail, but they are worth...
  21. That's who i ment, I give Farnsworth more credit...

    That's who i ment, I give Farnsworth more credit for TV, just like Tesla's power distribution was better then Edison's, That and Tesla coils are so fricken cool... just not next to an AVR
  22. Replies
    48
    Views
    1,273

    should tell him what they are worth with a little...

    should tell him what they are worth with a little TLC after you load them up and are driving off
  23. Replies
    10
    Views
    316

    torn surround on a monitor 10

    I replave the foam ones all the time on other speakers but was wondering is there are rubber versions for the 10 inch drivers if they had been torn my children, pets or a customer? most of my...
  24. Replies
    6
    Views
    288

    the Best way i have found is the peerless is a...

    the Best way i have found is the peerless is a small hole in the middle of there dome i think is a give away that's it's an older set
  25. Replies
    32
    Views
    926

    I love my 1b's a lot even though i burned out the...

    I love my 1b's a lot even though i burned out the tweeters twice , one was my mess up and the other was a power test, you will need to update the crossovers an a RD0194 was nice, i added a fast...
Results 1 to 25 of 97
Page 1 of 4 1 2 3 4