Search:

Oh - I also spent a lot of time with a protractor and a couple of test records to get things setup just right. Well worth the effort.

I've had good luck with the Shure M97xe - although it's probably not considered an audiophile cartridge i've been happy with the results. I used to use an older ortofon cartridge - TM14? which I...

I don't think I'll be much help without the service manual but you may want to post some pics on this thread so others can chime in.

I am not sure if there are seperate adjustments for the different lasers - if we had a service manual we could determine that...

I suppose there is also the possibility that you got a bum...

Did you replace the entire laser assembly or just the optical p/u? There may be seperate adjustments (small trim pots on the cd assembly pcb) that can be adjusted - generally there are a few test...

in with 10

I'm looking for a simpler way to integrate my passive sub into my 2.1 channel setup. Something similar to the paradigm X-30 would probably do the trick - anybody have anything like this they would...

A few years ago I rebuilt an old Denon DRA-395 for dad that I picked up for free on CL. Well the Denon has failed again and dad is interested in getting a new 2-channel receiver.

He has a...

Thanks for the quick replies - I just plugged them in and they have decent bass extension for their size but the HF is very bright - I don't think I could listen to them very long... looks like...

The grills say they're advents but i've never seen anything like this... they are also bass reflex. The lables have been removed from the back. The tops are some type of shiny plexi-type material. ...

The M-400A that I have at home is NOT common ground - internally carver inverts one channel and then swaps the +/- output jacks on that speaker output. (Basically the + of one channel's speaker...

sounds like SDA1C is leaving the forum and cancelling all pending sales/transactions... to me that would mean that # 11 is open again...

in with 8 please! (this would be perfect for me as I am a repair tech) :)

I was able to figure out a workaround last night for the placement of the TT so I will no longer need the extra phono pre. Thanks

Still for sale? If you still have the phono pre I would be interested in it. I just rearranged my listening room and the TT is too far from the amp so I will need an external pre to make it work. ...

Step 1 - get a multimeter

Step 2 - measure the resistance between the two ground posts on the Anthem amp

If the resistance is low (close to zero) then the amp is "common ground" which...

in with lucky 13 - nice karma

in for audio - nice Karma.

IN - nice Karma

I wouldn't expect the SA-W3000 to have any usable output anywhere close to 20hz. The plate amp it uses is rated at 100 watts into 6 ohms at 1% distortion 20hz-200 or 180 watts into 6 ohms at 80hz...

Most schematics do not explain specifics on troubleshooting unless there is some type of "test mode" built into the device. It sounds like this project may be a bit too much to tackle without some...

If the amp is in protection I would expect shorted output transistors, in addition to open emitter resistors, shorted pre-drivers etc... That being said, Ken is right, you need a schematic to...

oh - and if you have 4 RTI A5's you could setup a 4 channel (panambiophonics) and get a full 360 degrees of sound!

since the SDA effect is most simply put a passive means of cancelling crosstalk, why don't you go active and give ambiophonics a try. there is free software you can download to do this and the...

anyone heard of black acoustics? they look similar to some I have found but information is scarce...