Free Shipping on All Orders 1-866-764-1801

Vist our Online Store

Search:

Type: Posts; User: Polkcanada

Search: Search took 0.00 seconds.

  1. I am not able in access the classified for sale...

    I am not able in access the classified for sale section, so I thought I would ask my question here. I am just doing the final setup my home theatre set-up and I have some Kimber Kable that I have...
  2. Replies
    4
    Views
    970

    Need Help I just mounted my 702's they look great up on the...

    I just mounted my 702's they look great up on the wall but are they heavy. One screw we hit a stud. The other one we cutba hole in the wall, stuck a piece of 2'x4 in behind the drywall and screwed...
  3. Replies
    14
    Views
    1,180

    Need Help The Parasound A31 sounds amazing, I hope my wife...

    The Parasound A31 sounds amazing, I hope my wife likes her Valentine gift. The place I picked up the Parasound at was also a Kimber Kable dealer and the owner gave me a fantastic deal on them. So...
  4. Replies
    14
    Views
    1,180

    Need Help My eyes are burning from all the reading I did...

    My eyes are burning from all the reading I did last night on cables. I have read comments ranging from high end cables are snake oil to if I buy the right cable I will be able to hear Eddie Van...
  5. Replies
    14
    Views
    1,180

    Need Help Thanks for the help guys. I have decided not to...

    Thanks for the help guys. I have decided not to biamp or biwire but I am going to get a power amp. to drive the
    Left, right and centre.

    I have now turn my attention to the 3 cables I need to...
  6. Replies
    14
    Views
    1,180

    Need Help How about a Parasound A31 for the Left, Right and...

    How about a Parasound A31 for the Left, Right and Centre? And then let the ONKYO power the surrounds in a 5.1 o a future 7.1 setup. Would the ONYKO be enough to power 4 702 F/Xs?

    Thanks again...
  7. Replies
    14
    Views
    1,180

    Need Help EMOTIVA XPA-3 Three-Channel Power Amplifier...

    EMOTIVA XPA-3
    Three-Channel Power
    Amplifier
    Power output (all channels driven):
    300 watts RMS @ 4 ohm (0.1% THD)
    200 watts RMS @ 8 ohm (0.1% THD)

    Will this get the job done? I saw on one of...
  8. Replies
    14
    Views
    1,180

    Need Help Here are the specs. Amplifier Section ...

    Here are the specs.


    Amplifier Section


    Power Output -
    All Channels 145 W (8 ohms, 20 Hz-20 kHz,
    0.05%, 2 channels driven, FTC)
    Front L/R 145 W (8 ohms, 20 Hz-20...
  9. Replies
    14
    Views
    1,180

    Need Help How should I wire my set-up?

    Hello to all, I am new to the forms and I am setting up a new POLK system and I am trying to figure if I should bi wire and/or bi amp my setup. Any help would be greatly appreciated.

    I have an...
Results 1 to 9 of 9