Search:

I found this on the laundry room floor today.:D

Fine as long as the amp's cooling surfaces are unobstructed.

Sounds like ignition bleed over - perhaps plug wire noise.

Blown VCs are more often caused by distortion and clipping than by pure overpower conditions.

The enclosure actually changes the behavior of the driver(s) and alters their impedance.

Unless the impedance is Way weird, any good speaker will match any good amp.

So this is not a case of Franken-Polk?

Bummer, I just read this and missed them...

Sometimes you can read numbers off of the connector pad.

Deciding on grill color is always tough for me...

Enjoy!

Monstor Cable makes some great X-Terminator Posts and jacks.

I have been using Crown amplification...

That's a good one! :c)

Excellent. Thanks!

That's a great idea!

Wish I could help.

Hooray!

I have been told that the best way to isolate the mid/bass driver (now only midrange) from the (new - to be added) woofer is to shoot expanding foam into the top half of the enclosure inside a...

I hear you --- But..... Your reply IMplies that there ARE Frank-N-Polks out there doesn't it? Perhaps you can direct me to Frank's Forum, eh?

:)

Well, that's out. The speakers were a give-away to me, so I guess I'm given a turd and trying to silver plate it, eh?

:confused:

:)

Well, this comment has me laughing so hard that there is no way that I can see through the tears to perform the mod. And I am sure that every time I try to start I'll remember this comment...

Has anyone had any success adding an active 10" sub to the M7? If so, what Xover and cabinet mods did you make (if any)?

After exhaustively reading through all of the 'back issues' concerning the M7........

Hello all, Eiderlon here to ask if anyone has ever tried adding a 10" Subwoofer to the M7? If so, what Xover...