Search:

Been a while, need a pair. Any info appreciated.

Common ground amplifier, mono blocks? A little more information is needed. Pictures are a MAJOR plus.

Dude, as bad as the whole situation sucked(sucks)-IT COULD HAVE BEEN A LOT WORSE! It's hard to sit back and let Karma do it's thing, but that is the best thing to do. Because Karma NEVER forgets! ...

It depends on two and ONLY two factors:
1)-How deep your pockets are
2)-What sounds good to you

With that said, get what you like and compare what you had to what you have and go from there. ...

Elan isn't crappy gear(not cutting edge either). It's just now what you're needing. When I used to do whole home installs, that's what I used(been years ago). If you're wanting to power a couple...

M12's they be. Listen to them a while then do the RDO's and XO's to start. You'll need a HEALTHY amp to drive them(they do like the juice).

Pretty sure I JUST saw one on the bay.

Ken's right, and some is REALLY doesn't matter. BUT in your case, dude THAT SUCKS!

F1 nailed that one. Bi-amp them instead. Somewhere herein, someone built a high current variant of the A1(I think it was called the dreadnought or something to that effect-someone else will read...

I was using my 705 as a pre and it still got warm. Never went into standby though. Hook your stuff up to the 706 and listen to it at low volume and see if you hear anything out of place. Also-you...

Call customer service and MAKE SURE to tell them you are a Forum member. That'll give you a member discount. Kinda odd waiting to hear back from them-they always take my order up front.

Why would you put a non-Polk spec driver in it? It would wreak havoc with the XO and ultimately your sound(unless you change the XO and do BOTH speakers). I'd take Bobsama's advice, try to find...

Couldn't get the page to load. I'm saying it's both from the pics(have been wrong before).

It's Polk math at it's finest!

If you like to tinker on stuff get the Addy, otherwise the Emo is the ticket(IMO). Gordon has the right idea if you've got the coin though.

When I was using my 705 as a pre it got hot a lot. Make sure you have plenty of ventilation room because it will STILL GENERATE HEAT from the amps inside, just not as much. Gave mine room to breath...

MOST PA amps used to be listed as peak and program(RMS). That's the only bell going off right now.

May not be EXACTLY what you're looking for in a pre, BUT Onkyo makes a few and you can almost ALWAYS get them cheap on the bay. Just a thought.

I like Caddock's myself. HERE!

DUDE-let me know how those posts work out for you.

Someone said check MAF direction. I'm saying HO2 sensors and cats(should be like a dozen of them-seriously like 6 though).

YAMMIT!! You SDA guys have all the fun. IF I COULD(read if my wife would let me) own SDA's it'd be SRS's OR even CRS's(I think I'd like the CRS's better, but the bigguns is braggin' rights). I'M...

Use a DPDT to isolate the load and the charger. THEN fuse the load side at the battery. No worries then mate.

I posted a few days ago about an incident that my father had with his HK(went up in smoke). So I gave him my M-501. He is now a happy camper, and my good fortune has found me another one to play...

My fathers HK770 power amp puked on him tuesday. Today is his 55th birthday. He called me almost in tears tuesday about that. I told him not to stress over it. At one point he'd loaned me a...