Search:

Naw, just with a meter. I just wanted to know if there was a diff. And, it was to settle an argument with a buddy of mine running sound quality competitions. He sid that there was a "noticeable"...

dyslexic keyboard lol

The Knu is good wire, i have used both the Fleks and the KCA. I did notice a little more voltage loss with the KCA bot it was only a couple of hundredths of a volt. The Cadence on e-Bay is OFC and...

I understand that you are feeding each woofer 1000 watts. As you have it the amps are seeing a parallel(2 ohm) signal each=1000 watts. however if you run the subs voicecoils in a series(8 ohm) and go...

It is a mono amp. you willget 1000 watts. You have 2 + and 2 - side by side right????Test one side or the other it will be 1000 watts....

You are only going to get 1000 watts. you cannot strap them together like Sundown, orDiamond Audio to double the power.

I have located small kits on e-bay. The resins are good and clear, you don't need a vac pump or autoclave to make it set. However if you are making large pieces, it gets pretty intense and if you are...

I have been in this stuff for a long time. I can say that Rockford Fosgate wire is good, Memphis is FULL size Oxygen free copper, Cadence wire is good too. Budget builds are hard to do, but you get...

True that...If you are in the neighborhood of the RMS you will be fine. If you are ported use the subsonic filter.

I have a local shop that sells these silverado boxes for 10's 12's carpet, or rhino lined. I got one and it is 5/8 MDF down fire and it cost 50 bucks. They are built very well I have a pair of Boston...

Running two 1000/1's to only two subs??? you get 1000 watts at 6 ohms to 1.5 ohms.Save the 0/1 wire and tie the subs together. It will also save some time getting them balanced.

I have pulled good numbers both in sound quality and with spl. Bostons roll off very quickly in 1 cubic ft enclosures. And the 27 htz tones are impressive...Digital Designs are pretty much bullet...

I like to run my high end speakers through an amp, and my tweeters with tightly crossed over tweeters. Using the factory wires for tweets, and wire the amp to my other components. It adds just enough...

The limit is 100 watts RMS, a 50W x2 @ 4 Ohms, will get you to that magic number. Personally I stay in the 4 Ohm range due to THD(Total Harmonic Distortion) An amp is mearly a gain device. I have ran...