Search:

Would have liked to see this through to the end, but i guess everyone lost interest in the topic. I know you can't teleport here and fix it with a majick wand for me, but I would have at least liked...

Well, It was actually the female RCA JACK ON the AVR OR the cable not making contact on the male outer edge of the cable or vice versa. either way, I feel like the issue resides inside the amp itself...

Goddang it! So the right channel went out again. This time, it's making a clicking noise from my right channel's tweeter when I mute the TV or sometimes it will happen when a commercial ends. Here's...

How come we can't have avatars on the forums? boo:sad:

Well, it appears I have fixed the problem, FINALLY.

I would've never expected this but I guess this does occur over time.
Turns out that coax audio cable I had running from the DVR to the AVR...

Well, that avr seems to have only 80wpc. (not like i'm counting pennies here, but still..)
I don't need pre outs for this AVR. It's not that time in my life where adding an amp makes logistical or...

Dunno, I would imagine that it would be at least 200 to repair it, and at that point, I feel like I might as well throw down and get an upgraded AVR with as many HDMI ins as I would need. The right...

YEA I want some horsepower. Something I feel like the Pioneer lacked...

I really hate to bring this back, but my right front is acting up again. it seems that it's never permanently fixed but...

hate to bring this back, but my right front is acting up again. it seems that it's never permanently fixed but broken only when i want to watch a movie or play some games or impress my friends haha....

I'd love to know the recommended enclosure size for both an 8''db subwoofer and a 10'' db sub (dvc or non). I need to figure out how big the boxes will be for I have a small car (MKV VW Golf)
I...

I've really been looking at those elites again, but the denon's are a bit cheaper and have many of the same features. I'll do more research for sure before deciding. How long are these things...

I've now circumvented the issue by bi-amping the front mains off the surround back channel. Everything works ok now. I'll need to get a new aver around christmastime or maybe a little later but this...

I doubt I will add an amp before my next upgrade, right now I just need my right main working :) I'm wondering how much it would cost just to have the thing repaired..

Mantis: what leads you to believe that it's the right one for me? Not trying to pick fights, just want to know what logic lies behind the statement.

Ok, so I've come to the conclusion that my Pioneer Elite has officially bit the dust. (It pops every time I switch sources from the right front channel, all other channels work fine:confused: And...

Well, it seems as if the right channel pops every time I switch sources for audio. Still no sound from the right side front. I'm leaning more and more towards the fact that the side went out for...

Today I'll completely reset the entire receiver to try to figure out what the issue is and hope that solves something. Assuming the amp is the culprit here. Don't know, maybe the settings got really...

Well, I could always save it as a preset as well as writing them down.

In answer to your original question on how it sounds without MCACC: I've only heard it once without it and there's a reason...

Well, now I have an entirely new set of issues. Last thing I did was the MCACC setup before I went to work. I then attempted to watch a movie and now the right front channel doesn't work. At all....

Well, I lowered the cover freq. to 50hz, followed most of Mon40's advice and then re "MCACC'D" it. Then I realized that maybe if I put the receiver in THX modes it would cut some of the treble out....

That post brings up another question i had. Another thing I don't understand is the eq in the pioneer. There are options for "all channel adjust", "front align" and some others. When I change, say,...

I have an issue with my RTI's. I have my RTI8's hooked up as front L/R, a CSi5 for center, and two FX3's as surrounds. The fronts are bi-wired into my VSX-80TXV 7 channel receiver using the 6 and 7...

what are you "reporting" me for?

great, thanks guys. I'll be doing it as soon as i get over my flu like symptoms and it gets just a hair warmer out.

Thank you!:p

Those self-tapping screws can go right into the sheet metal and hold a small amp up? It couldn't be more than 10 lbs. I'm just concerned it'll fall off while she goes over speed bumps...