Free Shipping on All Orders 1-866-764-1801

Vist our Online Store

Search:

Type: Posts; User: POLKHT

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    18
    Views
    1,260

    ....

    ....
  2. Replies
    18
    Views
    1,260

    I have a pair of Cary Audio

    I have a pair of Cary Audio
  3. Replies
    18
    Views
    1,260

    Additional question? If I'm using a tube amp,...

    Additional question? If I'm using a tube amp, will it sound better hooked up to a tube pre vs. a SS pre? I am assuming that it will.

    Thanks.
  4. Replies
    18
    Views
    1,260

    I may be crazy. I understand that it is going to...

    I may be crazy. I understand that it is going to be difficult, to impossible to find one at that price range with those features. That's why I am asking the very knowledgeable people here.
    ...
  5. Replies
    18
    Views
    1,260

    Tube Preamp suggestions

    I'm looking for a tube preamp, with these requirements.

    1) Budget priced and inexpensive, under 200.00 used.
    2) 2 to 3 inputs and 2 outputs.
    3) remote for the volume control.

    This will be...
  6. Need Help Same here, but I have a pair of DIY JL 12W7. Not...

    Same here, but I have a pair of DIY JL 12W7. Not the best, but good enough for now. I was thinking of butt kickers, but decided to put the money into dual subs.
  7. Replies
    13
    Views
    1,384

    I agree, it might be the caps discharging. I...

    I agree, it might be the caps discharging. I also turn off the pre/receiver first, then the amp.

    The odd thing is that I only hear the whine from the B&W's, not the other brands of speakers I...
  8. Replies
    13
    Views
    1,384

    The amp was recently repaired. Had all the 3...

    The amp was recently repaired. Had all the 3 bias and 3 diodes replaced to fix a heating issue. I took it back to the shop and was told that there was nothing wrong with it. Turns out this only...
  9. Replies
    13
    Views
    1,384

    Thats exactly how I turn off my system. The pre...

    Thats exactly how I turn off my system. The pre first, then the amp goes off. It just came back from the shop. Had to replace the biases to fix a heat issue. It may have to go back.

    So, will...
  10. Replies
    13
    Views
    1,384

    Whinning noise damage speakers?

    I need some help. Does anyone know if the whinning noise caused by my amps capacitors discharging after being turned off damage my speakers? Thanks in advance.
  11. Replies
    2
    Views
    152

    Need Help tonyb, The amp I have is a Acurus A200x3. I...

    tonyb,
    The amp I have is a Acurus A200x3. I don't think the amp was on when I removed the cables.
  12. Replies
    2
    Views
    152

    Need Help Amp buzzing and whinning issues

    I'm having issues with my amp. First issue is that when I remove the RCA connections, right after the amp has been on, I get a buzzing noise. Second issue is that when I turn the amp off, a minute...
  13. Replies
    1
    Views
    187

    Nevermind. I listened to the center again, and...

    Nevermind. I listened to the center again, and could not hear any issues. I think I had it hooked up incorrectly. Please remove this thread if needed.
  14. Replies
    1
    Views
    187

    Polk CS1000p Subwoofer Driver MW 7015

    I'm still looking for a MW 7015. It's the outside driver.

    Thanks
  15. Replies
    0
    Views
    261

    Need Help Onkyo TX NR708 12 volt trigger

    I need some help using the 12 volt trigger on my Onkyo TX NR708. What I want to do is turn on the Onkyo with my Harmony remote and have it turn on my Panamax M5300-EX switched outlets automatically....
  16. Replies
    16
    Views
    4,065

    So lets say that I need a Behringer DSP1124P. ...

    So lets say that I need a Behringer DSP1124P. Can I use a SMS-1 to auto calibrate my two subs, then use those values from the SMS-1 to set the DSP1124P?
  17. Replies
    16
    Views
    4,065

    Agreed..... But I can get BFD for about 40.00...

    Agreed..... But I can get BFD for about 40.00 used.
  18. Replies
    16
    Views
    4,065

    I meant to say.....I assume that by using a SMS-1...

    I meant to say.....I assume that by using a SMS-1 or BFD, it would not make my subs sound worse.
  19. Replies
    16
    Views
    4,065

    I have not measured. I'm not sure if I even need...

    I have not measured. I'm not sure if I even need external equalization. But I have a Onkyo with Audyssey. I now want to use Audyssey, which I thought EQ'd my sub along with speakers. If the...
  20. Replies
    16
    Views
    4,065

    I'm now thinking that I might get a Behringer...

    I'm now thinking that I might get a Behringer BFD. From what I've read, it's cheaper, but it's more difficult to set up.
  21. Replies
    16
    Views
    4,065

    So they are similar, but I still will need to get...

    So they are similar, but I still will need to get a SMS-1. I was hoping that I would not have to get a SMS-1.
  22. Replies
    16
    Views
    4,065

    Audyssey MultEQ and Velodyne SMS-1

    Is using Audyssey MultEQ for my sub, the same as using a Velodyne SMS-1? Or are they totally different.

    Thanks.
  23. Replies
    17
    Views
    1,488

    I'll sugguest he go with 15's. Thanks everyone...

    I'll sugguest he go with 15's.
    Thanks everyone for the input and suggestions.

    If there are any other suggestions, I would like to read them.
  24. Replies
    17
    Views
    1,488

    Not sure what the max size of the box will be. I...

    Not sure what the max size of the box will be. I 'm sure he does not want to go with 18's, but I could be wrong.
  25. Replies
    17
    Views
    1,488

    Phasewolf, Well he has a Velodyne SMS-1, so I...

    Phasewolf,

    Well he has a Velodyne SMS-1, so I think that should correct the dips and peaks. I know very little to nothing in regards to the SMS-1, but I think it's supposed to fix those issues?
    ...
Results 1 to 25 of 119
Page 1 of 5 1 2 3 4