Beogram setup advice

[Rev. Hayes]

I picked up a 1602 today and I would like to not mess it up.

The suspension is super bouncy and I'm scared I might ruin the cart (like I did meat fisting an Adcom hc/E II not to long ago )

Any advice on this table would be much appreciated.

[mhardy6647]

Suspension in my TX-2 (tangential) is pretty light. The swingin' arm on your 1602 is very low mass; the cartridge high compliance. Should be OK.

{gratuitous and pointless TX-2 photo}



here's a 1602 thread from AK:
http://audiokarma.org/forums/showthread.php?t=209841

EDIT: Vinyl Engine's got the instruction manual if you don't have it (free registration required to d/l):
http://www.vinylengine.com/library/b...ram-1602.shtml