New here and tried searching, but didn't have any luck.
Just wondering what the best frequency to tune the box for my DB1040DVC would be? I'm not exactly sure which spec that would be on the spec sheet? Everything I've found show's frequency as Fb, but thats not listed in the specs... Is that the frequency response @28-200Hz or the Fs @37Hz (both from manual). Whats the difference between these 2 specs? Is one a range and the other ideal? One of the calculators (http://www.reaudio.com/speaker_box/LPort_Box_Calc.html) for my dimensions is showing tuned freq of 29.05Hz.
I want to start building, but a little unsure whats needed for the sub. Saw something about lower being better, as long as its not below 20Hz...It's going to be a slotted box (my first attempt at building ported/slotted). Also, if i slant the face on a slotted box, will that mess with the outcome? Hopefully this all makes sense.
Before the questions arise, I will be using 3/4" MDF, and aware of the importance to make it solid/tight. The amp used is Kicker MX700.5 Marine and this set-up is going in my boat, so box will be coated in rubberized coating.
Any help will be greatly appreciated. Thanks.