SR104-DVC on a Hifonics HFI1000.1D

[Priestslc]

So as the title says I have a SR104-DVC and a Hifonics HFI1000.1D amp coming and I want to make sure that I set this up right, I spent allot of money and have heard nothing but good things about both these products.

I plan on wiring the sub so I get a 2 Ohm load, the notes from the amp say
"2 ohms: 750 watts x 1 chan." and the Sub says "700 Watts of CONTINOUS power-handling capability! Seriously."

I will be running the sub in a .85 Cu Ft sealed enclosure.

So does anyone have some good advice for tuning this amp so the speaker preforms at it's higher capability without risking damage to either the Sub or the AMP?

I'll be mating this to a Kenwood Kiv-700 with a proper 4 gauge amp install kit.

Any helpful hints are greatly appreciated, I am so looking forward to getting this all installed! I hope it is on par with the SW7000 10" eclipse I use to own.

[DSkip]

Wrong forum. There is a car forum further down the main page that would be better suited.


Does the .85 include the displacement of the sub? On the amp, keep the bass boost off and set the gains correctly. If you don't know what that means, find out before you set it up. If you bought it new, give the sub some serious time to break in. That is one great sub. I run mine off about 100 watts and that is more than enough for me.

[Priestslc]

Sorry about that :\ I posted there.