Free Shipping on All Orders 1-866-764-1801

Vist our Online Store
+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Matt J
    Guest

    Unhappy Blowing Fuses! Help!

    Hello, I have 2 12" Polk/MOMOs running off of an Autotek-MX1300 at 2 ohm. It is pushing about 600x2. The problem is recently I just changed it from 4 ohm to 2 ohm and when i changed it to 2 ohm I blew a 40a, 60a, and 80a fuse in my 4awg power wire. Everything was running perfect when I was running at 4 ohm but when it came down to 2 ohm..this fuse popping problem arose. I didnt change any other connections other than running parrallel from series. The 80a fuse took about 2 minutes to melt and the 40a and 60a took about 30 seconds.
    What should/can I do to stop popping fuses left and right?

  2. #2

    Member Sales Rating: (0)

    Join Date
    Sep 2001
    Posts
    48

    Default i'm no expert but....

    this has happened to me too. i think its because your ohms are too low. the fuse burnin out is the amp protecting itself from overloading or you need smaller gauge wire. if i were you id run them parallel or something but i dont know what your power peaks are, so hopefully that will solve your problem.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts