Driver removal monior 5 7 10

[emionence1963]

Ok so I want to pull the driver from the cabinets just to get some P/N off the drivers. So here is the question????? If I pull the drivers off do I need to
re-glue the driver back on? If I pull the driver will it screw up the foam gasket that seals the driver to the front baffle? I wanna make sure the driver is sealed once I put the driver back on.
I think I have or will have a bad MW soon! There is a deformation on one of the drivers.
Dont have a pic with me to upload at this time. I bought the M7's several months ago and have been playing them, but not at extreme volume levels. Just a slight roar at times.
I have not noticed any scrapping of the voice coil or any difference is sounds comming out of the MW
I need to get a new MW for it, but my piggy bank at this time wont allow for it But when the cash outlay comes back I wanna b ready to get the MW on order There out there one day and gone the next! They sell fast.
Also the MW on my 7's are not sticky, like my 10's and 5's. Should that also be a concern?
If I should be worried about them being sticky then Im gonna need 2 MW instead of one

[F1nut]

1. No
2. No
3. No

[emionence1963]

Also I thought that the older Polks 7a's only had this cardboard ring around the drivers? This is a early 7b series speaker! According to the sticker on the back.