hey guys long time lurker first time poster here, had a polk sr124 for a few months in a sealed box (dvc, running at 2ohms)
anyway ive been upgrading and finally managed to get my hands on another one (getting hard to find now) and want to build a dual box (or 2 single boxes?) myself.
Now from reading here i would like to build something similar to polk's recommended 1.34 cf enclosure, but two of them, i would prefer to build a single enclosure to hold both subs.
i will be wiring these (both dual 4ohm) to 8ohm, then series back to 4ohm and powering with an alpine pdx m12.
now i am fine with carpentry and woodworking etc, want to build with 3/4" mdf and just build the standard rectangular box, few questions
1. if building a dual box, should there be a divider or some form of bracing through the middle? Would i be better off building 2 single box's then simply joining them together?
2. would someone more knowledgeable be able to help me out with a bit of a plan for these, i can follow instructions fine, but the design is where im not so good.
thanks in advance, looking forward to giving my SR a companion + the box it deserves.