Hello again. I have a question for you guys. I am going to have two seperate sealed boxes made for the SR124 subs that I have, (for space reasons). My issue is that I am going to be using the PDX M12 one channel amp for my power. With having two seperate boxes I can not wire the two subs together on one set of binding posts because they are not in the same box, and thus I will have a total of 4 wires.( I hope that made sense) However with the amp only being one channel, I dont see the 4 wires fitting inside the clips of the amp. So, my thought is I can us a T style distribution block like this one:
Take the positvie wire from the right sub, and take the positive of the left sub. Put the block like so, T and put one positive wire on one side, and put the other one on the other side. (do this for positive, and negative sides) then put a positive wire at the bottom of the T, and put that into the positive side of the amp. Would this work you think?