4 MM2124s in a bandpass box

[DemiSlayer2]

hello i want to put four of these 2124 subs in my bandpass box but i will have to face one of them to another one on one side and the same on the other side of the enclosure will this work well with these subs and also i want to run 1000watt amp to all for at the moment will want to upgrade to on 1000 watt per pair of subs but not sure it this configuration would work well ?

[sntnsupermen131]

how much space in between?
will they all have seperate sealed chambers?
-Cody

[DemiSlayer2]

Subs are right together like push/pull configuration

[DemiSlayer2]

what would be the wiring order on the subs that are right up to each other would one have to be out of phase than the other so it would be push/pull or should the phase be selected from the amp ?

[PoweredByDodge]

if they're bolted to each other -- wire one out of phase with the other. do it on the speaker -- easier to remember.

[DemiSlayer2]

I will need 2 amps then to wire one of them out of phase right ?

[PoweredByDodge]

no...

just flip the wires on one of the speakers...

if you had jsut two speakers lets say
and each were bolted to each other

and u wanted one outa phase with the other, one the same amp.

you'd run amp + to speaker 1 +, amp negative to speaker 1 -, then amp + to speaker 2 -, and amp - to speaker 2 +... get it?