Free Shipping on All Orders 1-866-764-1801

Vist our Online Store
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    Member Sales Rating: (0)

    Join Date
    May 2013

    Default amp settings for sub

    Just purchase a D2000.2 amp and a MM1240 Sub. I am going to run this speaker bridged off of the amp. I understand setting the gain with a multimeter, but how do I set the crossover on this amp exactly. There is a switch that has "full, hpf, Bpf" where to set that? what about the LPF and the HPF buttons? Where to set the HZ on both hpf and lpf? thanks in advance
    Last edited by bbrazil; 05-21-2013 at 04:54 PM.

  2. #2

    Member Sales Rating: (0)

    Join Date
    Sep 2010


    I am not sure how to run this amp in bridged mode since you want a low pass filter to be used only. The manual should possibly give you instructions on how to run the amp bridged? Good luck.
    KEF Q50 mains, M&K center, Boston Acoustics surround, marantz sr5001, pioneer dv-46av, sunfire hrs12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)


Similar Threads

  1. Need Help Need help with settings
    By Freestyle10461 in forum Speakers
    Replies: 2
    Last Post: 07-04-2011, 09:15 AM
  2. Help with settings
    By blobula in forum Speakers
    Replies: 5
    Last Post: 04-13-2011, 05:44 PM
  3. What's the best the settings?
    By bigones in forum Subwoofer Hookup & Bass Management
    Replies: 6
    Last Post: 12-13-2009, 10:24 AM
  4. Amp Settings
    By JoshParsons84 in forum Car Audio & Electronics
    Replies: 1
    Last Post: 11-24-2008, 12:39 AM
  5. Settings for R50's
    By FatnSlo in forum Speakers
    Replies: 1
    Last Post: 05-21-2008, 11:32 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts