So i did some research, but im paranoid so i wanted to double check.
I know nothing about insulation/etc...
It looks like i have Fiberglass insulation? I ripped out a small bit of it where my speaker was going to get it in. My question is should i cut all the insulation in the speaker mount area away? Im worried about the fiberglass potentially contacting some of the electronics on the backside of the speaker because its open and the insulation tends to expand out and will probably be resting across the entire backside of my Polk RC65i's
Heres some images, im worried both about the fiberglass being flammable from the heat the speaker electronics make, and im going to assume its not conductive so i dont need to worry about it shorting my speakers? All of the leads more or less look like they are protected except the ones on the big giant resistor/varistors.