Free Shipping on All Orders 1-866-764-1801

Vist our Online Store
+ Reply to Thread
Results 1 to 2 of 2
  1. #1

    Member Sales Rating: (0)

    Join Date
    Jul 2013

    Default Sub powered by PA500.4?

    I have a spare PA500.4 that I want to use to power my sub MM1040um. How should I connect for maximum wattage on sub woofer?

    Dynamic power rating 200w x 4 @ 2 ohms.
    RMS Continuous Bridged 250W x 2 @ 4 ohms

    Peak - 700W
    Continuous - 350W

  2. #2
    Polk Customer Service
    Member Sales Rating: (0)

    Join Date
    Jul 2001
    Polk Audio


    The only option would be to bridge the front channels to drive the single MM1040UM sub.
    This is a 4 Ohm woofer and this will give you an output power rating of 200 Watts.
    The rear channels will not be connected so I would recommend turning the gain level all the way down.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)


Similar Threads

  1. MMC6500 + PA500.4 = going active ???
    By Vital in forum Car Audio & Electronics
    Replies: 11
    Last Post: 04-23-2010, 12:51 AM
  2. Bridged PA500.4 question
    By Vital in forum Car Audio & Electronics
    Replies: 3
    Last Post: 03-16-2010, 03:13 PM
  3. Your take on Polk PA500
    By modmx in forum Car Audio & Electronics
    Replies: 26
    Last Post: 07-29-2009, 02:51 PM
  4. Hooking up Powered Subwoofer To Powered Amplifier Port
    By Camden350 in forum Subwoofer Hookup & Bass Management
    Replies: 2
    Last Post: 08-26-2008, 02:00 AM
  5. Need Help PA500.4 issues
    By hal9000k in forum Troubleshooting
    Replies: 1
    Last Post: 08-09-2008, 06:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts