Free Shipping on All Orders 1-866-764-1801

Vist our Online Store
+ Reply to Thread
Results 1 to 5 of 5
  1. #1

    Member Sales Rating: (0)

    Join Date
    Mar 2003
    Posts
    8

    Question Crossover Location

    OK, I've gotten replacement Crossovers for my SDA 2B's. Before I rip anything and everything apart looking for them could someone please tell me the location so I have to do minimal disassembly?

    Thanks
    gkellerman@niche-soft.com

  2. #2

    Member Sales Rating: (13)

    Join Date
    Mar 2002
    Location
    The Mars Hotel
    Posts
    30,429

    Default

    Take out the binding post plate (4 screws) on the back of the speaker cabinet, it should be attached to it. Or, you can take out the PR to gain access from the front.
    'Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."

  3. #3

    Member Sales Rating: (0)

    Join Date
    Mar 2003
    Posts
    8

    Default Crossover Location

    I done took those screws out but there are some wires attached to it that are somewhat taunt. There is an Allen Screw head about 6" above that plate. Is it possible the crossover is attached to that?
    gkellerman@niche-soft.com

  4. #4

    Member Sales Rating: (13)

    Join Date
    Mar 2002
    Location
    The Mars Hotel
    Posts
    30,429

    Default

    Yes, that's it. I couldn't remember exactly were it was, but knew it was right near the plate. It'll be easier to gain access by going through the front.
    'Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."

  5. #5

    Member Sales Rating: (0)

    Join Date
    Mar 2003
    Posts
    8

    Smile Crossover Location

    Thanks Nut. Looks like I'll wait until morning to go scrounging around in the garage for the Allen wrench set.
    gkellerman@niche-soft.com

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts