So I just bought Bills A2-300 sub. I need some help on figuring out how I should set it up. I have seen the following 2 setups and am unsure which I should do.
Option 1. Connect the LFE output from my AVR to the LFE input on the sub
Option 2. Connect the LFE output from my AVR to a Y-Splitter and connect to the RCA inputs on the sub
Which is going to be better? IIRC the reason folks do #2 is that it gives you a 3db boost to the signal which means a louder output but I could be wrong.
In addition I have the following questions:
Questions regarding Option 1
What LFE cable should I get? Would a cheap Blue Jeans Cable Belden interconnect work? Or should I go with something a bit more expensive? For now I have a 5m Audioquest Sidewinder I can steal from my 2 channel system, but need to get something for this sub.
Questions regarding Option 2
What LFE cable should I get? Should I go with the same sub cable and then just use a y-splitter at the end of it and if so what y splitter should I use or does it matter. Or do they make decently long cables that split at the end so you have one solid connection rather than using 2 cables?
Regarding placement, I plan on putting it between the loveseat and the entertainment center with the port firing toward the other wall. Its the only real place I can put it that wont be an issue. If I were to put it on the opposite side by the stairs, it would sit directly next to the air return and the entire wall the stairs is on is just drywall and then an empty hole all the way through to the bathroom at the front of the house. The corner I plan on putting it in has a brick exterior and then a insulated 2x4 wall. The rear wall is IIRC the firewall between my unit and my neighbors and may be concrete block, or at least thicker drywall than normal but I am not 100% sure.
I wont bore you with setup pictures, but my setup can be found here. I need to update the cable management pics since I no longer have MIT IC's and SC's as well as my equipment has changed as well.