This was much fun! I did not think it could be done... but it all fit!
Dang Trey! Is the cabinet gonna be deep enough? Dead sexy, though.
Dig it. I should be in your neck of the woods Monday-Tuesday....gimme a buzz
Modwright SWL 9.0 SE (6Sons Audio Thunderbird PC with Oyaide 004 terminations)
Consonance Cyber 800 tube monoblocks (6Sons Audio Thunderbird PC's with Oyaide 004 terminations)
Usher CP 6311
Phillips Pronto TS1000 Universal Remote
That's a tight fit! Nice work!
|Fronts - Peerless RTA-12B | Center(s) - Peerless Monitor 5 | Rears - Peerless Monitor 4 |
|Amp for fronts - Yamaha CA-1010 | Preamp (and amp for center/rears) - RX-V667 |
|TV - Philips 46" Smart LED | Gaming - Xbox One - Xbox 360 | Headphones - Philips Fidelio X1 |
Geezus Murphy man that's gorgeous...yes, one day you will mod my A7 crossovers...and if your real nice and by that time I could have a passport...I'll drive the towers down, make a vacay outta it and let you hear the results first hand !
Living Room Evolved
Polk Audio RTi A7 Black Front
Polk Audio RTi A3 Black Rear
Polk Audio CSiA6 Center
Transparent Audio Music Wave Biwire cables > Mains
Canare 4S11 >Center
Audioquest Evergreens on most of the analog connections
Tannoy TS2.12 Sub
Pro-Ject Debut Carbon Piano Black TT
Parasound Zphono Phono Preamp
Apple Mac Mini
Apple TV 3rd Gen
Sony PS3 160Gb/Microsoft XBox 360
Insignia 55 inch 120Hz TV
Beastly is the perfect term! Nice job!
Trey, do you rebuild them point to point? I don't see any crossover boards.
Usher CP-6311, Shuguang S200MK, Shuguang S845MK, Pioneer BDP-51fd, Essence Audio HDACC, Douglas IC's, Douglas Alpha bi-wire SC's, Pangea/Douglas PC's, Epson 8100
guess whoo gets test these bad boys out !!!!
Looks fantastic Trey, Fryed you're in for a serious listening treat.
Impressive. That's a large inductor on the bottom.
"Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills, polyswitches removed, Lg Solen inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips installed on back wall behind MW's & Tweeters, interior of cabinets sealed, AI-1 interface with 1000VA A-L transformer
Those are sexy!
Love the looks of those. I really considered doing the inductors when I did my last build, but could not justify spending more on the XO than I did the speaker after I purchased a set of LSiM 703. Wish they were coming to my area...
There are currently 1 users browsing this thread. (0 members and 1 guests)