So I've been looking at and bought some parts to build a DIY sub based on a Martycube (see pics).
So I've got the basic box design locked in.
So far these are the parts I have bought:
-Driver: Stereo Integrity 15" D2 woofer
-Amp: Dayton SA-1000 amplifier
-DSP/EQ: MiniDSP 2x4
-Mic: UMIK-1 mic (for use with REW)
-Gasket: Armacell (left over from db mod to my LSi 15's) - open to other suggestions if there is something better to use.
-Internal Wiring: Audioquest FLX 14/4 - leftover from other builds (open to other suggestions, need like 2m max of wire). Plan to only use 2 of the 4 connectors of the FLX as otherwise the gauge is too large.
Here are a couple parts I plan to buy:
RCA's: Kimber Kable PBJ 1m & .75m - these will connect AVR -> MiniDSP -> Dayton SA1000
Speaker Cable: 15 foot Kimber Kable single wire w/ standard banana's 8VS or 8PR
Foam: Acoustic Foam
Here is where I need your help. I am in need of help finding the following parts:
1 set of Binding posts.I am planning on having the binding posts be on the front baffle which will be ~1.5 inches thick. Looking for something decent. Can be in a kit with a cutout or independent.Bolts for mounting sub to baffleI am not sure what size bolt I need. Here is a link to measurements for the actual speaker. They need to be 1.5" long as thats the planned baffle depth. Prefer if they were black.Anything else you think I am missing
So anybody have some suggestions for the parts I need? Anybody have some suggested parts I dont have listed that I need?