Ok. So, I have a quick question. I have pretty much finished all the dynamate on the roof, Back wall, and sides, and both front, and back doors. On the doors I did the inside outter part of the door like in the pic.
then did outside panel where the speaker sits. I covered all the access holes as well. So, Im thinking that Im going to put another layer on the inside outter part of the door either with 1/8" poly form, or 1/8" bear hair type of insulation from like Second Skin or something. So, my question is if I do this Im going to need to cut out the access holes in order for me to do this, and want to know if I do this is there a need to cover them back up or can I just leave them open. And if by leaving them open will the door at that point act like an incolsure for the 6 1/2.
Sorry if not I did not explain very well.