Doing a rebuild on some SDA's and there was no filler so i did a guess as compared to what the placement was on my previous Monitor 7's and monitor 10's. Had it behind tweets and just to the top if the mids. Would this be sufficient enough or should i go lower with it? Any behind the passives?
Any help is much appreciated as always......
SDA Bound Pauly! :)
Buy Direct M-F 9am - 10:30pm EST 1-866-764-1801
Vist our Online Store
+ Reply to Thread
Results 1 to 5 of 5
Thread: SDA inside filler placement?????
-
10-05-2004 01:52 PM #1
SDA inside filler placement?????
Life without music would♭
-
10-05-2004 05:50 PM #2
Should be filler on the back and side walls down to the top of the PR, none around the PR at all.
'Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
-
10-06-2004 08:36 AM #3
I'll give that a try, thanks.
Life without music would♭
-
10-21-2004 11:42 PM #4
How about fillers on the SDA-crs? Should there be none also behind the radiators? Noticed mine had fillers between the front and back of speaker , should i move them ? tks a lot for any advise.
-
10-22-2004 11:52 AM #5
The acoustic dampening (filler) for the CRS is placed behind the stereo (inner) driver in each cabinet. Since the rear-firing passive radiator is directly behind the stereo driver, the filler sits between them.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts