Here are pictures and dimensions of, one version, of the original Monitor 5/ 7/ 10 "Polkstand" speaker stand.
Try to keep the thread clean, and post only related information if at all possible.
This would be considered the later version, i.e Mon10A+. I will get the "Polkstand Assembly Instructions" scanned into PDF and post them later. I will manually input them for your reading pleasure.
2 Bases (wood - PB - vinyl) 15 5/8" w x 13 5/8 d x 1 1/8" h
2 Columns (wood - PB - vinyl) 5" w x 5" d x 7 1/2" h
2 Tops (metal - stamped) 8" w x 8 5/8" d x 1/8" h + 6 degree tilt
2 Bolts (8 1/4" x 1/4")
1 Package of screws (#6 - 5/8")
Assemble each stand, per the diagram, in the following manner:
A. Insert the bolt through the hole in the top.
B. Holding the column an inch or two above the base, set the top in position on the column.
C. Locate the bolt in the holein the base, then locate the column in the groove in the base.
D. Tighten the bolt using a screwdriver, any U.S. coin will do. DO NOT OVERTIGHTEN.
The inside of the pamphlet includes a template for securing the stand to the aforementioned Monitor models. It is 11x17. If you would like a FREE photocopy of this, contact me directly.
Here is an additional notation from the inside.
For additional security, you may permanently fasten the stand to your loudspeaker using four #6 - 5/8" self tapping screws provided. (This is particularly recommended if you have young, clumsy children). In order to mount the stand permanently to your speaker, proceed as follows:
A. Position the template in the correct position on the bottom of the speaker. Fold over the sides and hold in place with small pieces of tape.
B. Use the nail provided to make a pilot hole about 1/8" deep at each of the four locations indicated on teh template, then remove the template.
C. Mount the assembled stand to the speaker with four #6 - 5/8" self tapping screws.
UNDER NO CIRCUMSTANCES SHOULD A LONGER SCREW THAN 5/8" BE USED, NOR SHOULD ANY HOLES BE DRILLED IN THE SPEAKER CABINET.