I have a diy old power supply kit i found and assembled for fun 0 -24 volts but low amps, or possibly MA, i want to use it for my sonic impact but it starts the amp clipping and light blinking and runs out of steam... I had a volt meter hooked up and the voltage holds so im sure its the amperage... how can i improve amperage on a circuit? It has a transformer, small board that i instaled a few caps, diodes? and a power? thing, lol.. with a heat sink on it... what ever that is.. so what would help increase the amps? Its small and i want to do point to point wireing to get rid of the board and stuff it in a small case to match my DIY SI amp... any help is appreciated..