I'm going to be hooking up a Polk C400.4 (in 75x4 mode) and a Kenwood 7201 (in 460x1 mode). I want to have a nice clean install, this will be going in a 2006 Mustang GT.
Could you use a distribution block for the two amp grounds? Or is that stupid?
Also, what size power and ground wires should I be using?
Any advice will be helpful.
Fronts: Polk MMC5250
Rear: Polk MMC570
Bass: (2) Polk MM2154DVC
Cap: 1farad Monster Digicap