polyswitches are ordered...where are they?

[autoconsortium]

They should be here early next week to repair my issue. I have the SDA 1.2's...where is this polyswitch? Which speaker do I take out to get to the switch. Thanks for your earlier help to diagnose this problem. Like you guys said, Polk is sending them free of charge. There is only one per speaker?

[Ricardo]

They are in the crossover; you need to take the crossover plate out, carefully. Not sure if the 1.2 is like the SRS or tthe 1.2TL. The SRS has the wires that go to drivers soldered to the crossover, while the 1.2TL has them with a connector. take a look, and if they have the connector you will be able to remove them easily; if they are soldered, then you need to decide if you want to desolder or cut (after carefully identifying them either way you go). Once you have the crosssover out, you should have no problem in identifying the polyswitches, desolder old ones and solder the new ones.

[autoconsortium]

I do have the SDA SRS

[thehaens@cox.net]

HT hit it, once you receive your new ones and you pull off your crossover, you will have no problem identifying. There is only one like it...

scott