i am looking for a carver amp dont know what size but i want one to drive my rear surounds
what are the good models and whitch would be good tostay away from? like ones that have a hum or make noise when you shut them off?
Buy Direct M-F 9am - 10:30pm EST 1-866-764-1801
Vist our Online Storei am looking for a carver amp dont know what size but i want one to drive my rear surounds
what are the good models and whitch would be good tostay away from? like ones that have a hum or make noise when you shut them off?
Gonzo's World
BenQ 8700+
115in screen
PS3,X-Box 360 and Wii
Sunfire Theater Grand III
ADCOM GFA-7607
four avalanch 18 subs 26.12l of displacement
Crown xti 4000
gonzo...
I haven't heard a Carver that I haven't liked. Anything preceeded by an "m" is good, vingtage Carver, when Bob was at the helm. One of my carvers is the m0.5t at 140wpc and it will drive my inefficient DQ-10's very, very well.
BDT
I ALWAYS use an ass-gasket. Never hover because of splash down and back splatter. I also float landing pad made from TP for a soft landing to avoid the above. One can never be too cautious when dealing with the general public. - RonP
I have a TFM-45 (375 wpc/ 8 ohms) that does a great job with the SDA 1.2's. My ears give out long before the amp or the speakers do!:D
Main System: Polk SDA SRS 1.2 Speakers, Sunfire Signature 600~two Amp, Carver C-16 Preamp, Carver TX-11b Tuner, Marantz 6350Q TT, Philips CDR-775 Recorder, Teac V-707RX Cassette Deck, Signal Cable Double Run Speaker Cable
Upstairs Den: Marantz 2325 Receiver, Marantz 5220 Cassette Deck, Marantz HD-880 Speakers, Marantz 6370Q TT
Exercise (Kabuki speaker) Room: Kenwood KR-9600 Receiver, Pioneer CS-99a Speakers, Sansui SP-X9000 Speakers (not pretty, but LOUD! :) )
There are currently 1 users browsing this thread. (0 members and 1 guests)